Robertson SR71 Hammer Zip Line Trolley

In stock
SKU
5065-E
$206.40
Using machined axles which may cost more but give the SR-71 Hammer zip line trolley unparalleled structural integrity.

SR71 Hammer Zip Line Trolley

The SR-71 Hammer Zip Line Trolley is a proven performer for zip line operations. Is built from .101 thick 304 stainless steel. Unlike the competition it is assembled using machined axles which may cost more but give the SR-71 Hammer zip line trolley unparalleled structural integrity. Safety is always a primary objective, and the SR-71 Hammer zip line trolley uses an additional back up bolt should there ever be a catastrophic failure during use. The sheaves are case hardened to a 56-58 Rockwell and spin on ball bearings to provide excellent wear characteristics in challenging outdoor environments. Built to accept two carabiners at the attachment point for extra safety. The new bent over design is perfect for use with a brake block without worrying about damaging your back-up connection.

Breaking strength:             19,000 lbs.

Manufacturer:                    Robertson Mtn., Henderson, NV, USA

Overall length:                   6"

Height:                             5 1/4"

Width:                              1 ½" (bolt end to bolt end)

Max cable diameter:           ½"

Min cable diameter:            3/16" (not recommended)

Clearance between wheels:  1 ½"

Wheel diameter:                 2"

Axel spacing:                     3 ½"

Max speed:                       70 mph

Weight:                             2 lb

Load opening:                    1 ½" x 1" (approx)

More Information
Manufacturer Robertson Harness
Write Your Own Review
You're reviewing:Robertson SR71 Hammer Zip Line Trolley
Back to Top
Close
Please enter your email address below to receive a password reset link.