Search results for: 'isc zip with belay'

Deep Cut Pole Auger Bits Learn More

Zipline Cable Ferrule - Zinc Plated, Two ferrules are required for life support and ziplining applications (ACCT Standards). The extra ferrule serves as a backup in case of primary ferrule failure due to defects or improper swaging. A 12 ton crimper/compression tool is required for 1/4" - 1/2" ferrules Learn More

Shoulder Eye Screw Lag, Use for connecting hand lines, spiders webs to trees, etc. on challenge courses. Do not use in life support applications. Also used when wrapping cable around a tree. Learn More

Nylon Shock Cord consists of a stranded rubber core covered with braided fiber resulting in an elastic cord with consistent stretch and strength. The durable "bungee type" cord is covered with nylon. Learn More

Used as spacers or supports under screw or bolt heads. Our washers are heat treated galvanized. Learn More

Fully adjustable full body harness intended for rope courses and adventure parks.

• CE 1019, EN12277, EN161
• front attachment point for belaying and rappeling according to EN 12277 type C
• waist belt and the leg loops without the padding enables to put the harness to every person
• rear steel D-ring with a bearing capacity of 15 kN according EN 361
• waist belt, shoulder straps and the leg loops are easily adjustable with easy lock buckles
• red webbing strap stitched into the buckles simplify handling with them
• all steel components are finished with E-coating technology for higher corrosion resistance
• left leg loop with red color helps to put the harness on
• waist belt webbing is in red as well for easier orientation in the harness
• dorsal plastic plate with different color according the size of the harness (S – yellow, UNI – red)
• construction ensures long-time operation and efficiency (easy releasing and fastening even when dirty and tough webbing)
• Rear dorsal plate for easy size identification. Yellow = Small. Red = Universal Sizing
• Weight: 1050g
• Size: S (110-150cm/43.3in -59in)/UNI (150cm-200cm/59in-79in)

Learn More

Lock washers are a critical component to through bolts on wood poles. Pole shrinkage mandates the use of double coil lock washers to keep pressure on the nut and bolt to prevent loosening. Learn More

Aspir Adjustable Harness, Its low bulk and large range of adjustability also make it great for mountaineering and glacier travel. A great harness too for via ferrata and adventure parks. Learn More

Ferrules must be properly crimped to achieve holding strength. Properly swaged ferrules can hold 90% of cable strength. Two ferrules are required for life support and ziplining applications (ACCT Standards). Learn More

Ferrules must be properly crimped to achieve holding strength. Properly swaged ferrules can hold 90% of cable strength. Two ferrules are required for life support and ziplining applications (ACCT Standards). Learn More

Ferrules must be properly crimped to achieve holding strength. Properly swaged ferrules can hold 90% of cable strength. Two ferrules are required for life support and ziplining applications (ACCT Standards). Learn More

Our Machine Bolts are hot dip galvanized, forged steel, quenched and tempered and are sold with hex nuts attached. Round or square washers and lock washers can be added separately. Learn More

Just Perfect Pole Steps : JP Steps Removable utility pole and tree steps. This is the step only. These steps can replace common utility pole steps that have an upturned hook end.

Learn More

The Felco C16 Wire Cutter has a capacity of 5/8 in. diameter and smaller. This is the GO-TO zipline cable cutter in the industry. Felco cutters keep cutting for years longer than other cable cutters. Learn More

Just Perfect Pole Steps : JP Steps Removable utility pole and tree steps

Learn More

Cable Clamp: Crosby Wire Rope Clip Learn More

Used to support cross timbers for ropes course, challenge course, zip lines and industrial applications. Learn More